Cantek ST152C Single End Tenoner

• 5 heads
• CSA Telemecanique switches

Top & Bottom Tenon Heads

• Carbide insert spiral tenon heads
• 1 ¼” dia. spindle
• 6″ long x 5″ thick tenons heads. Spiral with carbide insert tooling
• 2 x 5HP motors
• 3400 RPM
• 14 mm square carbide tips on end of cutterheads to produce clean cut shoulder
• 1″ lateral adjustment of tenon heads

2XCope Spindle Vertical Top&Bottom

• 1 ¼” dia. spindle, 6000 RPM
• 5HP motor to each cope head
• Max. dia. tooling 6-3/8″
• 2-3/4″ length of spindle
• Independent adjustment each head
• 2 x 4 knife wedge type cutterheads included
• Counterbore locknut allows both heads to move close together

Cut Off Saw

• 12″ dia. driven from tenon heads
• 1 ¼” shaft dia. x 6″ long
• 2800 RPM
• Saw position moved by changing spacers

Sliding Table Carriage

• Pneumatic holddown clamp for clamping work pieces onto traveling table
• Table size 50″ long x 17″ wide

 Options Included

• Set of Heads